DYNAMAT BULK PACK
Stop fighting engine rumble, speaker rattle, road noise and buzzing vehicle parts! Apply Dynamat Bulk Pack to your vehicles resonant surfaces and enjoy improved clarity, loudness and bass response from your car stereo. Xtreme Dynamat sheets are made of patented lightweight elastomeric butyl covered with aluminium. The sheet can be easily die cut to shape and placed onto the body surface. Xtreme Dynamat is used to treat metal panels, partitions, ducts, doors, bins, panels, and so forth in railroad cars, buses, automobiles, and ships. Xtreme Dynamat is also used for ventilation ducts, relay cabinets, steel furniture, home appliances, sink units, computer equipment, machine tools and many other objects that suffer from vibration-produced noise.
Xtreme Dynamat Bulk Pack is now available at much discounted price and gigantic savings. You can also have it delivered for free.
ORDER TODAY, and start enjoying more peaceful ride on your vehicle!
ENJOY MUSIC CLARITY IN YOUR VEHICLE WITH DYNAMAT BULK PACK
Stop fighting engine rumble, speaker rattle, road noise and buzzing vehicle parts! Apply Xtreme Dynamat to your vehicles resonant surfaces and enjoy improved clarity, loudness and bass response from your car stereo. High-performance Dynamat Xtreme is lighter than Dynamat Original, four times more effective, requires no heat to apply and is recommended for vehicle tops, sides and contoured areas. Dynamat Xtreme is coated with aluminum for high temperature areas such as firewalls and floors. Kit contains nine 18" x 32" pieces of Dynamat Xtreme for rear decks, doors, floors and trunk floors. Unlike Dynamat Original, Dynamat Xtreme is also recommended for trunk lids, roofs, quarter panels and under-hood installations.
A review:
I decided to go with Dynamat to reduce road noise in my Jeep Liberty as the all-terrain tires were unbearably loud at highway speeds after a few hours. Amazon had the best prices on the bulk packs by far so I bought two to cover all four doors and the floor of my Jeep Liberty. I ended up with two sheets (3 sq ft) left over which should be enough to cover the rear gate when I have an afternoon to kill.
The metal backing is incredibly sharp and it conducts electricity, so a co-worker warned me to take great care to ensure that the wires do not come into contact with any of the edges. It's no easier on your finger tips either! I found out the hard way that you should not cover any contact points between the trim panels and doors if you want the panels to fit as snugly as they did before the installation. With the great care and lessons learned, all four doors took approximately 20 hours to install and the floor took close to 30 more. I'm certain an experienced installer could have done the job in half the time.